Start by making an outline on the siding where you want to position the ledger board.
Ledger for deck roof.
The conventional approach to deck construction creates a dangerous condition.
Spacing ledgers off the wall can be a challenge when mounting ledgers to existing homes when the ceiling inside is finished.
The result can be rot and deck collapse.
The ledger board should be about 1 1 2 inches below the roof line of the mobile home.
Attach a 2 x 6 ledger board to the studs on the wall using lag bolts.
Our approach solves this by properly.
Then cut away the siding.
Many deck builders like to space the deck ledger away from the wall about in.
Build the roof for the porch onto the exterior wall of the mobile home.
Failure of the ledger can be caused by too few or undersized fasteners or by decay in the ledger or band joist.
A wood to wood connection between deck ledger and building structure in which the ledger wood gets wet regularly transfers moisture into the building structure and does not dry well.
Nail undersill trim j channel will also work over the bottom cut using 11 gauge aluminum nails.
The ledger should be attached before the foundation is built for a deck patio roof posts and other structure.
The ledger board also supports one end of the.
Ledger strips are less supportive than joist hangers.
Deck builders can contact them for instructions based on the conditions of each individual installation.
It is usually the first to be installed as it sets the base for the rest of the deck.
Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
This connection is critical since a failure here can cause a deck to collapse.
Where to attach a patio roof ledger.
Locating and mounting the ledger is normally a fairly easy process.
Detecting and correcting deck ledger problems around vinyl siding.
They are not ideal for whole house construction because they do not defray as much force from the joists and are more likely to fail via breaks or falling.
The ledger typically a 2 by 6 is usually designed to hold one end of the patio roof rafters.
A ledger board is the part that attaches the deck to the house.
Parts of a house attached patio roof.